Search:


Comp II LED Comp II SCX Black SCX Silver SCX White 60s Muscle MINI Factory Match Liquid Filled Non-Filled Direct Mount Engine Thermometers Accessories All Gauges
1" Dial (K) 1½" Dial (A) 2¼" Dial (B) 3" Dial (E) 3" Asphalt (E) 3" Bottom Mount (J) 3" Asphalt (J) 3" Adjustable (ADJ3) 5" Dial (G) 5" Adjustable (ADJ5) 5" Bottom Mount (GJ) Engine Thermometers Capillary Industrial All Thermometers
Utility, Lower Mount SS/Brass, Lower Mount SS/Brass, Center Back SS/Brass, U-Clamp SS/Brass, Panel Mount All SS, Lower Mount All SS, Panel Mount 4" All SS 4.5" Process Gauges
2" All SS (Q3) 2½" All SS (K) 2½" SS/Brass (J) 4" All SS (G) 4½" Process (MPB/SC) 6" All SS (H) All McDaniel Gauges
General Service Severe Service 63mm Severe Service 100mm Diaphragm Gauges Process Gauges All MARSH Gauges MARSH PDF Catalog
Address, Phone, Fax Request Info
Contact Us About Marshall Search Catalog FAQs Site Index

How do I calibrate my SCX gauge?

To change the calibration setting:

  1. To access calibration mode, turn the power to the gauge on with the CAL wire grounded. The CAL wire is the GREEN wire on Pin 3 of Connector 2 (see Fig 1 on SCX Instructions).
  2. The pointer will stop at 50% scale to indicate you have successfully accessed calibration mode.
  3. Once the pointer stops at 50% scale remove the CAL wire from the ground source. The pointer will move to indicate the current calibration setting per "Calibration Settings" below.
  4. To change the calibration setting, momentarily ground the CAL wire. Each time you momentarily ground the CAL wire, the calibration setting will change.
  5. When the desired calibration setting is obtained, leave the CAL wire ungrounded for 5 seconds. The gauge will save the new calibration setting, exit calibration mode and return to normal operating mode.

Calibration Settings

  • Vac/Boost with transducer (0.5-4.5V Output): 20% scale (12" Vac)
  • Volts, 8-18V: 0% scale (8V)
  • Oil Pressure with 9200 sender: 100% scale (100 PSI)
  • Water Temperature 100-260F with 9201 sender: 88% scale (240F)

Back to FAQs


About Us · Search Catalog · FAQs · Contact · Site Map · Home

©2024 Marshall Instruments, Inc.
Design: BWE, Inc.
  info@marshallinstruments.com
1-714-632-8565



  Auto Gauges Thermometers McDaniel Marsh